Exhaust Valve Gaskets for Polaris AXYS Pro RMK 800 2016-2018

Exhaust Valve Gaskets for Polaris AXYS Pro RMK 800

These exhaust valve gaskets seal the joint between the exhaust valve assemblies and the cylinder on Polaris AXYS Pro RMK 800 snowmobiles made from 2016 through 2018, keeping exhaust gases and pressure contained where they belong.

Overview

These exhaust valve gaskets are replacement sealing components for the exhaust valve system on Polaris AXYS Pro RMK 800 sleds built from 2016 to 2018. Each gasket creates a tight seal at the valve-to-cylinder junction, helping the exhaust valve operate correctly and preventing leaks that rob power. They are a practical service part for riders and shops performing top-end maintenance on these machines.

Built For Performance

• Direct-fit replacement for the exhaust valve gasket position on Polaris AXYS Pro RMK 800 engines
• Seals the exhaust valve to cylinder junction to contain combustion pressure
• Helps maintain correct exhaust valve operation and consistent power delivery
• Sold as a gasket set for the exhaust valve assembly service
• Compatible with Polaris 800 AXYS Pro RMK models from 2016 to 2018

Fits These Machines

• for Polaris AXYS Pro RMK 800, 2016
• for Polaris AXYS Pro RMK 800, 2017
• for Polaris AXYS Pro RMK 800, 2018

On-The-Job Use

• Top-end rebuilds and exhaust valve service on AXYS Pro RMK 800 sleds
• Resealing the exhaust valve joint after removing the valve assembly
• Routine maintenance to stop exhaust leaks at the cylinder junction
• Shop and trailside repairs where a dependable replacement gasket is needed

Specs At A Glance

Good To Know

Q: How many gaskets do I need for a full exhaust valve service? A: This set covers the exhaust valve gasket positions on the AXYS Pro RMK 800 engine. Check your service manual for the exact count required for your valve assembly.

Q: Can I reuse the old exhaust valve gaskets? A: Exhaust valve gaskets are a crush-style seal and are not designed to be reused once removed. Replace them any time the exhaust valve assembly is taken apart.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.