External Ignition Coil for John Deere Trailfire 440 1979-1982
External Ignition Coil for John Deere Trailfire 440 1979-1982
Couldn't load pickup availability
External Ignition Coil for John Deere Trailfire 440
This external ignition coil for John Deere Trailfire 440 snowmobiles from 1979 through 1982 delivers the high-voltage spark your engine needs to fire reliably.
Overview
This external ignition coil is a replacement electrical component built to feed spark to the plug on John Deere Trailfire 440 machines. It converts the low-voltage signal from the ignition system into the high-voltage charge that jumps the plug gap, keeping combustion consistent across the rev range. It suits riders maintaining or restoring a 1979 to 1982 Trailfire 440 who need a dependable ignition coil on hand.
Built For Performance
- External mount design matches the factory coil location on the Trailfire 440
- Wound to deliver consistent high-voltage output to the spark plug
- Housing sealed against snow, moisture, and vibration common to sled use
- Terminals positioned for straightforward wiring to the existing harness
- Drop-in replacement footprint for the original coil on 1979-1982 models
Fits These Machines
- for John Deere Trailfire 440, 1979
- for John Deere Trailfire 440, 1980
- for John Deere Trailfire 440, 1981
- for John Deere Trailfire 440, 1982
On-The-Job Use
- Replacing a weak or failed coil that causes hard starting or misfires
- Routine ignition service on a vintage Trailfire 440
- Restoring spark on a sled that has sat unused
- Keeping a spare coil in the trailer for trailside repairs
Specs At A Glance
| Part Type | External Ignition Coil |
| Machine | for John Deere Trailfire 440 |
| Model Years | 1979-1982 |
| Mount Style | External |
Good To Know
Q: How do I know the coil is the problem? A: A weak or dead coil often shows as no spark, hard starting, or misfiring under load. Testing the coil output with a spark tester before ordering helps confirm the fault.
Q: Do I need to replace the plug or wires at the same time? A: It is good practice to inspect the spark plug, cap, and wiring while the coil is off. Worn secondary components can mask a new coil's performance.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
