F0D-U153E-10-00 Nozzle Cable for Yamaha XLT 800 2002-2004

Nozzle Cable for Yamaha

This nozzle cable for Yamaha links the steering or trim control to the jet nozzle on compatible XLT 800 watercraft, allowing the rider to direct thrust; it cross-references OEM part number F0D-U153E-10-00.

Overview

This nozzle cable for Yamaha is a replacement control cable for the jet nozzle assembly on XLT 800 models. It carries lever movement through to the nozzle so steering and thrust direction respond correctly. It is intended for riders and shops replacing a worn, stiff, or broken nozzle cable.

Built For Performance

• Built to OEM cross-reference F0D-U153E-10-00 for a proper fit
• Corrosion-resistant sheath and inner cable suited to constant water exposure
• Pre-formed end fittings for simple attachment at both ends
• Travel length matched to the original cable for correct nozzle range
• Rugged construction handles repeated steering input on the water

Fits These Machines

• for Yamaha XLT 800 2002
• for Yamaha XLT 800 2003
• for Yamaha XLT 800 2004

On-The-Job Use

• Replacing a nozzle cable that has seized or snapped
• Restoring accurate steering and nozzle response on a used ski
• Scheduled control cable maintenance on XLT 800 craft
• Repair shop jobs requiring an OEM cross-referenced cable

Specs At A Glance

Good To Know

Q: Will this cable fit all XLT 800 years listed? A: It is designed for the 2002 through 2004 range shown, but routing and mounts can differ, so verify against your serial number before ordering. Q: Should the cable be adjusted after fitting? A: Yes, set the nozzle travel at the lever stop so full steering range is available without binding.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.