F1B-U153D-01-00 Upper Trim Cable for Yamaha FX 140 1000 2002-2004

Upper Trim Cable for Yamaha

This upper trim cable, reference F1B-U153D-01-00, links the handlebar trim switch to the nozzle assembly so trim angle can be adjusted on the water.

Overview

The upper trim cable is a replacement control cable for personal watercraft, carrying trim input from the switch down to the nozzle linkage. It is built to match the factory routing so trim feel stays consistent. This upper trim cable fits owners servicing a Yamaha FX 140.

Built For Performance

• Cross-reference F1B-U153D-01-00 for simple part lookup
• Pre-formed sheath follows the stock cable path
• Corrosion-resistant inner cable built for marine use
• Threaded fittings match the trim switch and nozzle ends
• Flexible jacket resists kinking along the steering run

Fits These Machines

• for Yamaha FX 140 1000, 2002-2004

On-The-Job Use

• Refreshing trim control on a used FX 140
• Replacing a stretched or seized cable
• Pre-season control and driveline service
• Freshwater and saltwater use where cable wear occurs

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: This is an aftermarket upper trim cable that cross-references F1B-U153D-01-00. Verify your model and year before ordering.

Q: Does the cable come pre-lubricated? A: Cables of this type typically arrive ready to install, though a light marine grease on the fittings helps long-term. Check the routing before tightening the ends.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.