F1W-6153E-01-00 Trim Cable for Yamaha FX HO 1800 2009-2011

Trim Cable for Yamaha FX HO 1800

This trim cable for Yamaha FX HO 1800 watercraft replaces OEM part F1W-6153E-01-00 to control the jet nozzle trim angle for steady handling and ride adjustment.

Overview

This trim cable for Yamaha FX HO 1800 models from 2009 through 2011 delivers precise trim control at the handlebar so riders can adjust the jet nozzle angle on the water. Built as a direct replacement cable for part F1W-6153E-01-00, it restores the trim function when an old cable binds, stretches, or snaps. It suits personal watercraft owners performing routine maintenance or a full trim system repair.

Built For Performance

• Direct replacement for OEM part number F1W-6153E-01-00
• Inner cable runs smooth inside a flexible outer sheath for low-friction trim movement
• Corrosion-resistant construction suited to constant marine exposure
• Pre-formed end fittings match the original connection points
• Built to withstand repeated trim adjustment under load
• Fits Yamaha FX HO 1800 models from 2009 to 2011

Fits These Machines

• for Yamaha FX HO 1800 (2009-2011)

On-The-Job Use

• Replacing a stretched or broken trim cable on a personal watercraft
• Restoring handlebar trim control for jet nozzle angle adjustment
• Routine driveline and control cable maintenance
• Seasonal servicing before launching the craft

Specs At A Glance

Good To Know

Q: Does this trim cable fit models outside the listed years? A: This cable is listed for Yamaha FX HO 1800 models from 2009 to 2011, so confirm your model year and serial number before ordering. A:

Q: Is any special tool needed for installation? A: Basic hand tools are typically sufficient, but routing the cable correctly through the hull matters for smooth trim operation, so follow your service manual.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.