Fan Switch Sensor for Kawasaki Prairie 650 4x4 2002-2003
Fan Switch Sensor for Kawasaki Prairie 650 4x4 2002-2003
Couldn't load pickup availability
Fan Switch Sensor for Kawasaki Prairie 700 4x4
This fan switch sensor is a replacement electrical component that activates the cooling fan on your ATV when engine temperature reaches the set threshold, keeping your machine within safe operating range.
Overview
The fan switch sensor for Kawasaki Prairie 700 4x4 is a direct-fit replacement that monitors coolant temperature and triggers the cooling fan at the correct point. It installs in place of the original sensor and restores proper fan operation so your engine stays cool during slow-speed riding and heavy utility work. This fan switch sensor suits riders performing routine maintenance or replacing a failed temperature sensor on their Prairie 700 4x4.
Built For Performance
- Threaded body designed to match the factory sensor port on the Prairie 700 4x4
- Temperature-actuated contact closes the fan circuit at the specified threshold
- Sealed electrical connector resists moisture, mud, and vibration
- Durable housing built to withstand engine bay heat and trail conditions
- Direct replacement for a failed or inaccurate factory fan switch
Fits These Machines
- for Kawasaki Prairie 700 4x4 2004
- for Kawasaki Prairie 700 4x4 2005
- for Kawasaki Prairie 700 4x4 2006
On-The-Job Use
- Replacing a failed fan switch that leaves the cooling fan running constantly
- Restoring fan activation on machines that overheat during slow utility work
- Routine cooling system service on the Prairie 700 4x4
- Trailside repair after a sensor failure cuts fan operation
Specs At A Glance
| Part Number(s) | Fan Switch Sensor |
| Component Type | Temperature-activated fan switch sensor |
| Compatibility | for Kawasaki Prairie 700 4x4 2004-2006 |
Good To Know
Q: How do I know if my fan switch sensor has failed? A: A dead fan switch usually means the fan never turns on and the engine runs hot, while a stuck one leaves the fan running continuously with the key on. Either symptom points to replacement.
Q: Does this sensor require any wiring changes? A: It is built to plug into the factory connector and thread into the stock sensor port, so no rewiring is normally needed. Confirm your model year before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
