Flame Arrestor Gasket for Kawasaki JS 550 SX 550 1987-1990 PWC

Flame Arrestor Gasket for Kawasaki

This flame arrestor gasket for Kawasaki is a replacement sealing component that sits between the flame arrestor and carburetor on JS 550 and SX 550 watercraft, helping maintain a proper seal in the intake path.

Overview

This flame arrestor gasket for Kawasaki is a sealing component made to fit between the flame arrestor and the carburetor intake on JS 550 and SX 550 models. It helps keep the intake path sealed so the engine draws air correctly. It is intended for riders servicing or rebuilding the intake side of their personal watercraft.

Built For Performance

• Seals the joint between the flame arrestor and carburetor
• Helps maintain a stable intake seal under engine vibration
• Resists fuel vapor and heat exposure in the engine bay
• Suited to routine intake maintenance and carburetor service
• Compatible with JS 550 and SX 550 model years 1987-1990

Fits These Machines

• for Kawasaki JS 550
• for Kawasaki SX 550

On-The-Job Use

• Carburetor and intake servicing on 550 series watercraft
• Replacing worn or hardened gaskets during tune-ups
• Flame arrestor removal and reinstallation jobs
• Routine maintenance to keep the intake path sealed

Specs At A Glance

Good To Know

Q: Will this gasket fit both the JS 550 and SX 550? A: Yes, this gasket is listed for both the JS 550 and SX 550 across the 1987-1990 model years. Q: Should this gasket be replaced during carburetor work? A: Replacing it whenever the flame arrestor is removed is recommended, since old gaskets can dry out and allow air leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.