FOR 1992-1998 AUDI 2.8L V6 SOHC NEW CRANKSHAFT CRANK SHAFT POSITION SENSOR

Crankshaft Position Sensor for Audi 2.8L V6 SOHC

New crankshaft crank shaft position sensor built for 1992-1998 Audi 2.8L V6 SOHC engines, delivering the crank signal the engine management system needs for proper timing and starting.

Overview

This crankshaft position sensor is a new replacement component for 1992-1998 Audi models equipped with the 2.8L V6 SOHC engine. It reads crankshaft rotation and sends that signal to the engine computer so ignition and fuel delivery stay properly timed. It suits owners and technicians chasing no-start, misfire, or stalling faults traced to a failed crank sensor.

Built For Performance

• New sensor built for the 2.8L V6 SOHC engine application
• Delivers crankshaft position signal for correct ignition timing
• Direct replacement for a failed or intermittent original sensor
• Plug-in electrical connection for straightforward installation
• Designed for the 1992-1998 Audi model range

Fits These Machines

• for Audi models with the 2.8L V6 SOHC engine, 1992-1998

On-The-Job Use

• Fixing no-start or hard-start conditions linked to crank signal loss
• Resolving misfires and rough running caused by a faulty sensor
• Routine ignition system diagnostics and repair

Specs At A Glance

Good To Know

Q: Can a bad crankshaft position sensor cause a no-start? A: Yes, a failed crank sensor often cuts the signal the computer needs to fire the ignition, leading to no-start or stalling. Replacing it restores the timing reference.

Q: Should I check the connector and wiring first? A: Inspect the harness and connector for damage or corrosion before replacing the sensor, since wiring faults can mimic sensor failure. Confirm your engine code matches this part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.