For 1998-2003 Blazer S10 Jimmy Sonoma Upper & Lower Steering Column Cover Shroud

Upper & Lower Steering Column Cover Shroud for Chevrolet and GMC

This upper and lower steering column cover shroud protects internal steering components and restores the interior appearance of the vehicle dashboard assembly.

Overview

The upper and lower steering column cover shroud is a replacement housing designed to enclose the steering column for 1998 through 2003 compact trucks and SUVs. This upper and lower steering column cover shroud provides a clean finish while shielding wiring and ignition components from dust and debris. Technicians and vehicle owners use this upper and lower steering column cover shroud to replace cracked or missing original plastic trim pieces.

Built For Performance

• Constructed from high density automotive grade plastic for impact resistance.
• Two piece design includes both the upper and lower sections of the steering column housing.
• Precision molded mounting points facilitate secure attachment to the steering column.
• Textured finish matches the factory interior aesthetics of compatible vehicles.
• Includes necessary cutouts for the ignition switch and steering column levers.
• Resistant to warping or cracking under temperature fluctuations inside the cabin.

Fits These Machines

• for Chevrolet Blazer 1998 to 2003
• for Chevrolet S10 1998 to 2003
• for GMC Jimmy 1998 to 2001
• for GMC Sonoma 1998 to 2003

On-The-Job Use

• Restoring the interior of high mileage work trucks or daily drivers.
• Protecting exposed steering column wiring from accidental damage or short circuits.
• Replacing damaged trim after ignition cylinder repairs or column maintenance.
• Securing the upper and lower halves of the column housing after a rebuild.

Specs At A Glance

Good To Know

Q: Does this assembly include the mounting screws? A: This set typically includes the plastic upper and lower housings and relies on existing hardware for installation. Check the existing mounting points for damage before beginning the replacement process.

Q: Is any modification required for installation? A: This part is molded to match factory specifications for the listed vehicle years and models. Alignment with the ignition switch and tilt lever is preconfigured for a standard fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.