For 20-23 GMC Acadia SL SLE SLT Denali LED Tail Light Brake Lamp Passenger Side

LED Tail Light Brake Lamp Passenger Side for GMC

This LED tail light brake lamp replaces the passenger side rear light assembly on 2020-2023 GMC Acadia models, providing crisp illumination and a direct fit for SL, SLE, SLT, and Denali trims.

Overview

The LED tail light brake lamp assembly for the passenger side of the 2020-2023 GMC Acadia restores factory rear lighting performance. This tail light uses bright LED emitters to deliver fast, reliable brake and tail illumination, making it an essential replacement for cracked, faded, or non-functioning originals. Designed for GMC Acadia owners who need a direct plug-and-play solution, this LED tail light meets on-road safety requirements while matching the vehicle’s styling.

Built For Performance

• SAE and DOT compliant photometrics for legal on-road use
• High-output red LEDs for quick brake light response and long service life
• Weather-sealed polycarbonate lens and housing protect against moisture and dust
• Direct plug-and-play connector, no wire splicing or coding required
• Precision-molded housing matches factory mounting points for a gap-free fit
• UV-resistant lens coating resists yellowing and hazing over time

Fits These Machines

• for GMC Acadia SL 2020-2023
• for GMC Acadia SLE 2020-2023
• for GMC Acadia SLT 2020-2023
• for GMC Acadia Denali 2020-2023

On-The-Job Use

• Replacing a broken or water-damaged tail light after a collision or parking lot incident
• Restoring full rear brake, running, and turn signal visibility to pass state inspections
• Swapping out a cloudy or faded lens that reduces light output
• Refreshing the rear appearance when one factory lamp unit fails prematurely
• Ensuring safe nighttime driving and clear signaling for the vehicle’s passenger side

Specs At A Glance

Good To Know

Q: Does this tail light fit the driver’s side? A: No, this assembly is designed exclusively for the passenger side and will not mount correctly on the driver’s side. Verify you need the right-hand unit before ordering.

Q: Will I need to modify any wiring to install this LED tail light? A: It uses the factory bulb connectors and plugs directly into your Acadia’s existing harness, so no splicing or additional resistors are required.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.