For 97-06 Jeep Wrangler TJ Rear Trail Passenger/RH Control Arm Frame Rust Repair

Rear Trail Passenger/RH Control Arm Frame Rust Repair for Jeep

This rear trail passenger-side (right-hand) control arm frame rust repair panel is designed to replace corroded sections on 1997-2006 Jeep Wrangler TJ models, restoring structural integrity.

Overview

This rear trail passenger/RH control arm frame rust repair panel provides a direct-fit solution for patching rusted areas on the rear frame of the Jeep Wrangler TJ. It is engineered to match the original control arm mounting points and restores the passenger-side frame section to factory condition.

Built For Performance

• Heavy-gauge steel construction for long-lasting durability
• Pre-formed to match OEM frame contours
• E-coat primer finish resists corrosion
• Includes drilled holes for control arm bolt alignment
• Designed for weld-in installation with no trimming required

Fits These Machines

• for 1997-2006 Jeep Wrangler TJ

On-The-Job Use

• Repairing rusted rear control arm frame sections on Jeep Wrangler TJ
• Restoring passenger-side frame integrity after salt or moisture damage
• Replacing damaged factory panel without full frame replacement

Specs At A Glance

Good To Know

Q: How is this repair panel installed? A: It is typically welded into place after cutting out the rusted area, restoring the factory control arm mounting point.

Q: Does this panel include hardware? A: No, it is a bare repair panel designed for welding; bolts and brackets must be reused or purchased separately.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.