For Polaris Magnum 325 Magnum 330 Magnum 425 /500 Carburetor + Fuel Pump Kit

Carburetor + Fuel Pump Kit for Polaris Magnum 325 330 425 500

This carburetor and fuel pump kit is a direct replacement assembly for Polaris Magnum 325, 330, 425, and 500 models, delivering the air and fuel metering these utility ATVs need to start, idle, and pull cleanly under load.

Overview

This carburetor and fuel pump kit gives Polaris Magnum 325, Magnum 330, Magnum 425, and Magnum 500 owners a complete fuel delivery replacement in one package. The carburetor meters air and fuel to the engine while the included pump keeps a steady supply from the tank, so the machine runs right through cold starts and steady trail riding. It is built for riders and shops handling routine rebuilds, hard-starting fixes, and fuel system refreshes on these classic Polaris utility quads.

Built For Performance

• Complete assembly combining carburetor and fuel pump in a single kit
• Cast body construction with machined passages for consistent fuel metering
• Includes throttle and choke provisions sized to the Magnum powerplant
• Fuel pump delivers steady flow under load and across varying tank levels
• Gasket and seal surfaces finished for a clean, leak-free install
• Factory-style mounting points match the original equipment location

Fits These Machines

• for Polaris Magnum 325
• for Polaris Magnum 330
• for Polaris Magnum 425
• for Polaris Magnum 500

On-The-Job Use

• Replacing a worn or gummed carburetor on a hard-starting Magnum
• Restoring consistent fuel delivery for farm and property chores
• Refreshing the fuel system during routine seasonal maintenance
• Getting a project or stored machine running again
• Trail and hunting season prep for utility ATVs

Specs At A Glance

Good To Know

Q: Does this kit fit every year of the listed Magnum models? A: Fitment can vary by year and engine configuration, so confirm your exact model and serial number before ordering.

Q: Will I need to adjust anything after installing the carburetor? A: Idle speed and mixture settings are typically fine-tuned after installation for smooth running on your specific machine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.