For Toyota Camry, Celica, MR2-Interior Window Crank Handle Lever - Gray

Interior Window Crank Handle for Toyota

This interior window crank handle lever is the cabin component that lets you roll the side glass up or down by hand, and it is designed to fit Toyota models such as the Camry, Celica, and MR2.

Overview

This interior window crank handle restores manual window operation on vehicles with roll-up glass. The lever mounts to the window regulator shaft so you can raise and lower the window from inside the cabin. It is a practical replacement for a cracked, stripped, or missing handle on Toyota Camry, Celica, and MR2 models.

Built For Performance

• Gray finish matches common factory interior trim tones
• Lever design gives a secure grip for rolling the glass up and down
• Direct-fit replacement for a worn or broken interior window crank handle
• Mounts to the window regulator shaft for manual window operation
• Sold as a single handle lever

Fits These Machines

• for Toyota Camry
• for Toyota Celica
• for Toyota MR2

On-The-Job Use

• Restoring manual window operation on older Toyota vehicles
• Replacing a cracked or stripped interior window crank handle
• Interior trim refresh on a project or daily-driven Camry, Celica, or MR2

Specs At A Glance

Good To Know

Q: Does this handle fit both front and rear doors? A: Fitment depends on the door and model year, so confirm which window position you are replacing before ordering. Check your vehicle's door panel and regulator shaft before installation.

Q: What should I check before buying this crank handle? A: Confirm your Toyota model, year, and door position match the listing. Also inspect the window regulator shaft to make sure it is intact and not stripped.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.