Fork Seal and Wiper Set for Suzuki JR80 JR 80 2001-2004

Fork Seal and Wiper Set for Suzuki JR 80

This fork seal and wiper set for Suzuki JR 80 restores the front suspension seals on 2001-2004 JR80 models, replacing worn seals that allow oil to escape and dirt to enter the fork legs.

Overview

This fork seal and wiper set for Suzuki JR 80 gives you fresh seals and dust wipers to rebuild the front forks on your JR80. Worn fork seals cause oil leaks, poor damping, and premature bushing wear on these small off-road machines. This set is for riders and mechanics maintaining 2001-2004 JR80 forks that need a proper reseal.

Built For Performance

• Seal and wiper combination designed to keep fork oil in and contaminants out
• Rubber construction resists oil breakdown and UV exposure
• Direct replacement for the original seal and dust wiper positions
• Keeps fork action consistent by preventing oil loss through the seal lip
• Sold as a complete set for both fork legs

Fits These Machines

• for Suzuki JR 80 (2001)
• for Suzuki JR 80 (2002)
• for Suzuki JR 80 (2003)
• for Suzuki JR 80 (2004)

On-The-Job Use

• Routine fork service on JR80 minis
• Fixing oil weeping around the fork seal area
• Fork rebuilds after replacing bent or pitted tubes
• Pre-ride maintenance on trail and track bikes

Specs At A Glance

Good To Know

Q: Do I need to remove the forks to install these seals? A: In most cases the fork legs are removed and disassembled to drive out the old seals and seat the new ones properly. Follow your model's service manual for the exact procedure.

Q: How often should fork seals be replaced? A: Replace them whenever you see oil weeping down the fork tube or after a fork rebuild. Dirty wipers should also be cleaned or replaced at the same time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.