Fork Seal Set for Husqvarna TE400 TE 400 2001
Fork Seal Set for Husqvarna TE400 TE 400 2001
Couldn't load pickup availability
Fork Seal Set for Husqvarna TE400
This fork seal set is a direct replacement for the front suspension seals on a 2001 Husqvarna TE400, keeping fork oil where it belongs and dirt where it does not.
Overview
This fork seal set for Husqvarna TE400 gives you fresh seals for both fork legs on a 2001 TE 400. The set restores proper damping by stopping oil weep and blocking grit from entering the fork internals. Riders rebuilding tired front ends will find this fork seal set for Husqvarna TE400 a straightforward service part for regular maintenance.
Built For Performance
- Seals both fork legs in a single set for a complete front end refresh
- Dual lip design keeps fork oil contained under compression
- Wiper edge scrapes dust and grit before it reaches the oil seal
- Resists breakdown from fork oil and UV exposure
- Direct fit on 2001 TE400 fork tubes
Fits These Machines
- for Husqvarna TE400 2001
- for Husqvarna TE 400 2001
On-The-Job Use
- Routine fork servicing on enduro and trail bikes
- Fixing weeping or leaking fork seals before they soak the brake pads
- Full suspension rebuilds after a season of riding
- Preventive maintenance ahead of a long ride
Specs At A Glance
| Part Number(s) | TE400 Fork Seal Set |
| Type | Fork seal set |
| Position | Front fork |
| Compatibility | 2001 Husqvarna TE400 |
Good To Know
Q: Do I need to replace both fork seals at once? A: Yes, both legs see the same wear, so replacing them together avoids a second teardown. A complete set also keeps damping balanced side to side.
Q: Can I install these without special tools? A: A seal driver and basic hand tools are typical for this job. Take care not to nick the seal lip during installation to avoid a fresh leak.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
