Fork Seal Set for KTM Duke 690 2009-2010
Fork Seal Set for KTM Duke 690 2009-2010
Couldn't load pickup availability
Fork Seal Set for KTM Duke 690
This fork seal set for KTM Duke 690 2009-2010 models replaces worn or leaking seals in the front forks to keep damping oil sealed in and fork performance consistent.
Overview
This fork seal set is intended for the KTM Duke 690 built between 2009 and 2010. It renews the sealing surface in the front forks so oil stays contained and damping remains predictable. Anyone servicing a KTM Duke 690 will find this fork seal set a straightforward replacement for aging seals.
Built For Performance
- Direct replacement for the original fork seals on 2009-2010 KTM Duke 690 models
- Dual lip construction helps hold fork oil through compression and rebound
- Withstands suspension fluid, heat, and continuous cycling
- Stops oil weeping that can reach brake pads and fork tubes
- Supplied as a set to cover both fork legs in one service
Fits These Machines
- for KTM Duke 690 2009
- for KTM Duke 690 2010
On-The-Job Use
- Fork rebuilds and routine seal replacement
- Correcting oil leaks that cause poor damping and fork dive
- Street and canyon riding maintenance on WP-equipped Duke forks
- Pre-season service to prevent mid-ride seal failure
Specs At A Glance
| Part Number(s) | Fork Seal Set |
| Fitment Years | 2009-2010 |
| Application | Front fork seals |
| Machine | KTM Duke 690 |
Good To Know
Q: What are the signs of worn fork seals? A: Oil film on the fork tubes, drips under the front end, and inconsistent damping all point to worn seals that should be replaced. Q: Can I install these seals without removing the forks? A: Seal replacement normally requires removing and disassembling the forks, and a seal driver plus the service manual helps ensure correct oil level and air gap.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
