Fork Seal Set for KTM EGS 360 1997 EGS360
Fork Seal Set for KTM EGS 360 1997 EGS360
Couldn't load pickup availability
Fork Seal Set for KTM EGS 360
This fork seal set is a direct replacement for the front fork on a 1997 KTM EGS 360, restoring proper damping and keeping oil where it belongs.
Overview
This fork seal set is built to replace worn or leaking seals on the front forks of a 1997 KTM EGS 360. It keeps fork oil contained and dirt out, helping the suspension stay consistent on every ride. Riders rebuilding their forks will find this fork seal set a practical solution for a job that demands clean, reliable sealing.
Built For Performance
- Seals the fork leg to prevent oil loss and pressure drop
- Blocks dust and grit from entering the fork internals
- Restores smooth, predictable fork action
- Fits OEM fork dimensions for the EGS 360 application
- Sold as a set to service both fork legs
Fits These Machines
- for KTM EGS 360, 1997
On-The-Job Use
- Routine fork servicing and seal replacement
- Trail and enduro riding where fork contamination is common
- Suspension rebuilds after oil leaks appear
- Pre-ride maintenance to prevent seal failure on long rides
Specs At A Glance
| Part Number(s) | EGS360 |
| Vehicle | KTM EGS 360, 1997 |
| Component | Fork Seal Set |
Good To Know
Q: Do I need to replace both seals at once? A: Replacing both fork seals at the same time is standard practice, since seals on the same fork typically wear at a similar rate. This set covers both legs.
Q: Will fresh seals stop an existing oil leak? A: Yes, in most cases a leaking fork leg is caused by worn or damaged seals, so replacing them restores the seal and stops the leak. Confirm the fork tubes are not scored before installing.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
