Fork Seal Set for Triumph Daytona 675 R 2013-2016

Fork Seal Set for Triumph Daytona 675 R

This fork seal set for Triumph Daytona 675 R models from 2013 to 2016 replaces leaking or worn front fork seals to restore proper damping and keep fork oil sealed inside the fork legs.

Overview

This fork seal set is built for the Triumph Daytona 675 R produced between 2013 and 2016. It renews the sealing surface on both fork legs so oil stays contained and the front suspension responds as intended. Riders and technicians servicing the front end will find this fork seal set for Triumph Daytona 675 R a practical replacement for tired original seals.

Built For Performance

• Two-piece seal set covering both fork legs
• Made from oil-resistant elastomer for long service life
• Holds fork oil under pressure during hard braking and cornering
• Blocks dust and debris from entering the fork internals
• Sized to match the fork tube diameter of the Daytona 675 R

Fits These Machines

• for Triumph Daytona 675 R 2013
• for Triumph Daytona 675 R 2014
• for Triumph Daytona 675 R 2015
• for Triumph Daytona 675 R 2016

On-The-Job Use

• Routine fork oil and seal service
• Fixing leaks that leave oil on the fork tube and brake area
• Restoring front suspension feel on older Daytona 675 R bikes
• Workshop rebuilds of the front fork assembly

Specs At A Glance

Good To Know

Q: How do I know my fork seals need replacing? A: Oil film on the fork tubes, oil pooling near the dust seal, and reduced damping are the usual signs. If the front end feels soft or bouncy, the seals are likely due.

Q: Do I need any special tools to fit this set? A: A seal driver matched to the fork tube size makes the job easier, and fresh fork oil should be used at the same time. Check your service manual for the correct oil volume.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.