Fork Seal Set for Triumph Daytona 900 1995-1996

Fork Seal Set for Triumph Daytona 900

This fork seal set is a direct replacement for the front fork seals on a Triumph Daytona 900, sealing the fork legs to keep oil in and road grit out.

Overview

A fork seal set for the Triumph Daytona 900 restores the front suspension by replacing worn seals that let fork oil weep past the tubes. Each set is built to the original dimensions so it seats properly in the fork leg. Riders and mechanics use it during routine fork servicing on the Daytona 900.

Built For Performance

• Seals to the original fork leg dimensions for a precise fit
• Keeps fork oil contained so damping stays consistent
• Blocks dust and grit from reaching the fork internals
• Dual-lip design reduces weeping under load
• Sold as a set for both fork legs

Fits These Machines

• for Triumph Daytona 900 (1995-1996)

On-The-Job Use

• Scheduled front fork servicing
• Rebuilding forks after an oil leak is found
• Restoring a stored or project Daytona 900
• Replacing hardened or cracked seals during a refresh

Specs At A Glance

Good To Know

Q: How often should fork seals be replaced? A: Replace them at the interval your service manual lists, or sooner if oil weeps down the fork tube. Visible leaking or a spongy front end usually points to worn seals.

Q: Do I need to drain the fork oil first? A: Yes, the fork legs must be separated and the old oil removed before new seals go in. Fit the seals with the correct driver so they seat square without damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.