Front Drive Sprocket 14 Tooth for Suzuki RM 60 RM 100 2003 RM60 RM100

14 Tooth Front Drive Sprocket for Suzuki RM 60 and RM 100

This 14 tooth front drive sprocket is a direct replacement for the countershaft sprocket on Suzuki RM 60 and RM 100 models, restoring clean power transfer to the rear wheel.

Overview

This 14 tooth front drive sprocket is built for Suzuki RM 60 and RM 100 machines, giving riders a fresh countershaft sprocket that keeps the chain driving the rear wheel smoothly. A worn front drive sprocket can cause chain slap, uneven wear, and lost acceleration, so replacing it on the RM 60 or RM 100 restores crisp response. It suits riders maintaining 2003 and similar model year bikes for trail or track use.

Built For Performance

• 14 tooth count matched to the original countershaft sprocket sizing
• Steel construction for long service life under chain load
• Precision cut teeth for clean chain engagement and reduced wear
• Direct fitment onto the countershaft without modification
• Designed to run with standard RM 60 and RM 100 chains

Fits These Machines

• for Suzuki RM 60
• for Suzuki RM 100

On-The-Job Use

• Motocross and trail riding on RM 60 and RM 100 machines
• Routine drivetrain refresh when chains and sprockets are replaced together
• Restoring factory gearing after sprocket tooth wear
• Keep as a spare for race day chain and sprocket changes

Specs At A Glance

Good To Know

Q: Should I replace the rear sprocket and chain at the same time? A: Yes, a new front sprocket wears fastest against a worn chain and rear sprocket, so replacing all three together keeps wear even. A2:

Q: Does this sprocket need any special tools to install? A: A standard countershaft nut and retaining clip setup is used, so basic hand tools and a torque wrench are enough.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.