Front Right Control Arm and Ball Joint Assembly for Infiniti M35 M45 06-10 RWD

Front Right Control Arm and Ball Joint Assembly for Infiniti M35 and M45

This front right control arm and ball joint assembly replaces the worn unit on 2006 through 2010 rear-wheel-drive Infiniti M35 and M45 models.

Overview

This front right control arm and ball joint assembly is a direct replacement for a worn or damaged factory unit. It combines the control arm and ball joint in one assembly, restoring front suspension geometry and steering response on rear-wheel-drive M35 and M45 cars. It suits owners and shops handling front-end suspension repair.

Built For Performance

• Control arm and ball joint combined in one preassembled unit
• Designed for the front right position
• Built for rear-wheel-drive chassis applications
• Consistent geometry for predictable front-end alignment
• Simplifies replacement by fitting the arm and joint together

Fits These Machines

• for Infiniti M35, 2006 through 2010, rear-wheel drive
• for Infiniti M45, 2006 through 2010, rear-wheel drive

On-The-Job Use

• Correcting clunks or play from a worn front ball joint
• Restoring steering feel and front-end alignment
• Routine suspension refresh on higher-mileage M35 and M45 cars
• Front right corner repair after curb or road impact

Specs At A Glance

Good To Know

Q: Does this fit all-wheel-drive models? A: This assembly is listed for rear-wheel-drive M35 and M45 models, so verify your drivetrain before ordering.

Q: Should both front control arms be replaced together? A: Replacing both sides at once is often recommended when both show similar wear, and an alignment should follow installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.