Front Right Shock Strut Spring Assy For Mercedes W211 S211 E350 4Matic 2006-2009

Front Right Shock Strut Spring Assembly for Mercedes W211 S211 E350 4Matic

This front right shock strut spring assembly is a complete, pre-assembled suspension unit that replaces the worn strut on your vehicle to restore ride control and handling. The combined strut and coil spring design allows a direct swap without a spring compressor, cutting installation time while renewing damping performance.

Overview

This front right shock strut spring assembly gives your Mercedes W211 or S211 E350 4Matic a ready-to-install suspension replacement in one box. The pre-assembled strut and spring unit restores damping control, ride height, and steering stability on the right front corner. It suits owners and technicians handling a worn or leaking strut without the hassle of separate spring assembly work.

Built For Performance

• Complete assembly with strut, coil spring, and mount for a single-part replacement
• Pre-assembled layout removes the need for a spring compressor during installation
• Gas-charged damping design engineered to match factory suspension behavior
• Direct-fit geometry for the W211 and S211 chassis front right position
• Corrosion-resistant finish on the strut body for longer service life

Fits These Machines

• for Mercedes W211 E350 4Matic (2006-2009) front right position
• for Mercedes S211 E350 4Matic (2006-2009) front right position

On-The-Job Use

• Replacing a leaking or blown front strut on daily-driven E350 4Matic vehicles
• Restoring ride height and handling after suspension wear on the right front corner
• Shop and DIY suspension refresh work where a quick bolt-on swap is needed

Specs At A Glance

Good To Know

Q: Is this a direct replacement for my original front right strut? A: It is a complete assembly intended to replace the front right strut and spring unit on W211 and S211 E350 4Matic vehicles. Confirm your chassis code and position before ordering.

Q: Do I need a spring compressor to install this assembly? A: No, the spring comes pre-assembled onto the strut, so the unit installs as a single piece. Reuse the existing mounting hardware where specified.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.