Front Right Side Door Lock Actuator for Nissan Frontier 2.5L l4 4.0L V6 05-19
Front Right Side Door Lock Actuator for Nissan Frontier 2.5L l4 4.0L V6 05-19
Couldn't load pickup availability
Front Right Side Door Lock Actuator for Nissan Frontier
This front right side door lock actuator is a direct-fit replacement assembly that restores reliable power locking and unlocking on the passenger front door of 2005 through 2019 Nissan Frontier trucks with the 2.5L four-cylinder or 4.0L V6 engine.
Overview
This door lock actuator for Nissan Frontier replaces a failed factory latch motor so the passenger front door locks and unlocks with the key fob, door switch, or interior button again. It is built as a drop-in assembly for the front right door and suits DIY owners and shops servicing high-mileage trucks. When the original actuator stops engaging, this unit brings the power lock circuit back to normal operation.
Built For Performance
- Direct-fit replacement for the front right passenger door latch actuator assembly
- Electric motor and gear drive designed for consistent lock and unlock travel
- Housing shaped to match the factory mounting points for straightforward installation
- Connects to the existing door lock wiring harness without modification
- Sealed construction helps resist dust and moisture inside the door cavity
- Tested for repeated lock and unlock cycles
Fits These Machines
- for Nissan Frontier 2.5L l4 models 2005 through 2019
- for Nissan Frontier 4.0L V6 models 2005 through 2019
- Front right passenger door position
On-The-Job Use
- Restoring power locks on daily-driven Frontier trucks
- Replacing an actuator that no longer responds to the key fob
- Fixing slow or partial lock travel on the passenger front door
- Door lock repair during interior trim or window service
Specs At A Glance
| Position | Front right, passenger side |
| Function | Power door lock and unlock |
| Vehicle | for Nissan Frontier 2.5L l4 and 4.0L V6, 2005-2019 |
| Includes | Actuator assembly |
Good To Know
Q: Will this actuator work on either front door? A: No, this unit is built for the front right passenger door. The driver side uses a different assembly.
Q: Do I need to reprogram anything after installing it? A: No programming is required. It plugs into the existing door lock harness and works with the truck's factory power lock system.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
