Front Track Drive Sprocket for Ski-Doo Citation 300 1978-1979

Front Track Drive Sprocket for Ski-Doo Citation 300

This front track drive sprocket is a replacement component for the 1978-1979 Ski-Doo Citation 300 snowmobile, mounting on the drive axle to engage the track and deliver engine power to the ground.

Overview

This front track drive sprocket is made for the 1978-1979 Ski-Doo Citation 300 and installs on the drive axle to turn the track. When the original front track drive sprocket for Ski-Doo wears out, the track can slip or lose drive entirely, so replacing it keeps a Citation 300 running as intended.

Built For Performance

• Direct-fit replacement for the front drive position on the Citation 300 track axle
• Sprocket teeth shaped to mesh with the track's internal drive lugs
• Wear-resistant construction suited to continuous track engagement
• Configured for the 1978-1979 Citation 300 drive axle
• Replaces a cracked, chipped, or worn original sprocket

Fits These Machines

• for Ski-Doo Citation 300 (1978-1979)

On-The-Job Use

• Refreshing the track drive on a vintage Citation 300
• Replacing sprockets stripped by years of hard track use
• Track and axle service where drive sprockets show wear
• Keeping an older Ski-Doo trail-ready for the season

Specs At A Glance

Good To Know

Q: What causes a front drive sprocket to fail? A: Over time the sprocket teeth wear down or crack from constant contact with the track lugs, and a loose or misaligned track speeds that up. Replacing the sprocket when teeth round off prevents track slip and further drivetrain damage.

Q: Is this sprocket correct for both the 1978 and 1979 Citation 300? A: It is listed for the 1978-1979 Citation 300, though mid-production changes are possible on machines this old. Confirm your model year and compare against the sprocket being replaced before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.