Front Upper OR Lower A-Arm Bearing kit for Honda FourTrax 300 2x4 4x4 1988-2000

Front Upper OR Lower A-Arm Bearing Kit

This front upper or lower A-arm bearing kit is designed for Honda FourTrax 300 2x4 and 4x4 models from 1988 to 2000, allowing replacement of worn A-arm bushings.

Overview

This A-arm bearing kit for Honda FourTrax 300 provides the necessary bearings and seals for front upper or lower control arms. The kit fits both 2x4 and 4x4 versions produced between 1988 and 2000. Restoring suspension on a FourTrax 300 is straightforward with this kit.

Built For Performance

• Includes bearings and seals for one A-arm
• Precision-ground bearing surfaces for smooth operation
• Dust seals protect against dirt and moisture
• Restores proper suspension geometry
• Direct replacement for OEM components

Fits These Machines

• for Honda FourTrax 300 2x4 1988-2000
• for Honda FourTrax 300 4x4 1988-2000

On-The-Job Use

• Front suspension rebuild
• Replacement of worn or loose A-arm pivot points
• Off-road trail riding and utility use
• Restoration of older Honda ATVs

Specs At A Glance

Good To Know

Q: Do I need to replace both upper and lower bearings? A: It is recommended to replace both sides, though this kit is for one individual A-arm.

Q: Will this kit fit the rear A-arms? A: No, this kit is specifically for front A-arms only.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.