Front Wheel Bearing OR Rear Axle Bearing 2001-02 fits Polaris Magnum 325 4x4 HDS

Front or Rear Wheel Bearing for Polaris

This wheel bearing serves as a critical component for Polaris Magnum 325 4x4 HDS models to reduce friction between the axle and wheel hub during rotation.

Overview

The wheel bearing is engineered to provide smooth and consistent rotation for your machine's wheel assembly. Each wheel bearing is manufactured to meet or exceed original equipment performance standards for the Polaris Magnum 325. This wheel bearing is a essential maintenance part for riders demanding reliable operation in various terrains.

Built For Performance

• High speed steel ball construction
• Rubber seals prevent moisture and dirt entry
• Pre-greased for immediate installation
• Precision tolerances for reduced vibration

Fits These Machines

• for Polaris Magnum 325 4x4 HDS 2001
• for Polaris Magnum 325 4x4 HDS 2002

On-The-Job Use

• Replacing worn bearings after deep mud riding
• Correcting excessive play in the wheel hub
• Routine maintenance during axle service

Good To Know

Q: Does this bearing work for both front and rear positions? A: Yes, this bearing is compatible with both front and rear axle locations on the specified models.

Q: Should I replace bearings in pairs? A: It is recommended to replace wheel bearings on the same axle at the same time to ensure even wear.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.