Front Wheel Bearing & Seal Kit 1989-1999 for Yamaha Big Bear 350 4x4 & 2x4

Front Wheel Bearing & Seal Kit for Yamaha

This front wheel bearing & seal kit for Yamaha provides the necessary hardware to maintain smooth rotation for Big Bear 350 models from 1989 through 1999.

Overview

This front wheel bearing & seal kit for Yamaha is crafted to replace worn bearing assemblies that cause front-end instability. By installing this front wheel bearing & seal kit for Yamaha, you effectively seal your hub against moisture and debris during heavy work. This kit helps keep your Big Bear performing consistently under load.

Built For Performance

• Tough steel construction for longevity
• Seals feature advanced dirt-repelling design
• Precision-engineered for factory hub fitment
• Low friction for improved fuel efficiency
• Reliable operation under heavy utility loads

Fits These Machines

• for Yamaha Big Bear 350 4x4 1989-1999
• for Yamaha Big Bear 350 2x4 1989-1999

On-The-Job Use

• Maintenance for agricultural or utility quads
• Repairing wheel hub wear after heavy use
• Restoring handling to high-mileage machines

Specs At A Glance

Good To Know

Q: Is there a specific direction to install the seals? A: The open side of the seal should typically face towards the internal grease area. A: Correct orientation is vital to keeping mud out and grease inside the bearing.

Q: Should I replace the spindle nut too? A: It is good practice to inspect the spindle nut and cotter pin for wear while you have the hub disassembled. A: Replacing worn hardware ensures your hub assembly stays securely fastened.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.