Front Windshield LH-RH Wiper Cowl Extension Trim For 13-19 Toyota RAV4

Front Windshield LH-RH Wiper Cowl Extension Trim for Toyota

This front windshield LH-RH wiper cowl extension trim for Toyota replaces damaged or missing plastic components located at the base of the windshield to prevent debris from entering the engine compartment.

Overview

This front windshield LH-RH wiper cowl extension trim for Toyota is designed to restore the protective seal and aesthetic appearance of the vehicle cowl area. The front windshield LH-RH wiper cowl extension trim helps direct water runoff away from the cabin air intake while protecting internal components from road grime. Drivers can maintain the exterior integrity of their vehicle by installing this high quality front windshield LH-RH wiper cowl extension trim.

Built For Performance

• Manufactured from weather-resistant plastic to withstand extreme temperature fluctuations.
• Molded to follow the specific curvature of the lower windshield frame.
• Includes both the left-hand and right-hand side trim pieces for a full replacement.
• Resists ultraviolet degradation to prevent whitening or cracking over time.
• Provides a secure fit to help minimize wind noise at highway speeds.

Fits These Machines

• for Toyota RAV4 2013
• for Toyota RAV4 2014
• for Toyota RAV4 2015
• for Toyota RAV4 2016
• for Toyota RAV4 2017
• for Toyota RAV4 2018
• for Toyota RAV4 2019

On-The-Job Use

• Restoring the factory look of the cowl assembly after years of sun exposure.
• Replacing brittle plastic components during a windshield glass service.
• Shielding the mechanical wiper linkage from leaves and environmental debris.
• Ensuring proper water drainage away from the engine bay.

Specs At A Glance

Good To Know

Q: Does this set include pieces for both sides of the vehicle? A: This kit contains both the driver side and passenger side extension trims to ensure a uniform appearance and complete protection for the cowl area.

Q: Are additional fasteners required for the installation process? A: These trim pieces are designed to snap into existing mounting points, though reusing original clips or sourcing new standard fasteners is often necessary for a secure hold.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.