Fuel Injection Pressure Sensor For 02-04 Ford International 6.0L DSL Powerstroke

Fuel Injection Pressure Sensor for Ford International 6.0L DSL Powerstroke

This fuel injection pressure sensor measures the high-pressure oil circuit on 6.0L Powerstroke diesel engines and sends that reading to the engine computer for accurate fuel delivery.

Overview

This fuel injection pressure sensor is a direct-fit replacement for the high-pressure oil side of the 6.0L Powerstroke diesel engine. The sensor reads injection pressure and reports it to the PCM so fuel timing and volume stay correct. It suits owners of 2002 to 2004 Ford and International trucks chasing rough running, hard starts, or pressure-related fault codes.

Built For Performance

• Reads high-pressure oil circuit values for the 6.0L diesel injection system
• Direct-fit replacement for the original sensor location
• Sealed connector body resists oil and heat exposure
• Compatible with 2002 through 2004 model year applications
• Restores accurate pressure signal to the engine computer

Fits These Machines

• for Ford trucks with the 6.0L Powerstroke diesel, 2002 to 2004
• for International vehicles running the 6.0L diesel, 2002 to 2004

On-The-Job Use

• Diagnosing and repairing hard-start or no-start conditions
• Fixing rough idle and poor throttle response traced to pressure faults
• Routine maintenance on aging 6.0L diesel injection systems
• Fleet service where pressure sensor failure causes derates

Specs At A Glance

Good To Know

Q: Will this sensor fix a hard-start condition? A: A failed pressure sensor can cause hard starts and rough running, but always pull fault codes first to confirm the sensor is the cause.

Q: Does this fit any 6.0L diesel? A: It is listed for 2002 to 2004 Ford and International 6.0L diesel applications, so verify your model year and engine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.