Full Gasket Set Kit for Honda TRX250X TRX 250X 1987-1992

Connecting Rod Kit for Honda TRX200

This connecting rod kit is a direct replacement for the 1984 Honda TRX200, cross-referencing OEM part number 13202-427-300, and restores proper crank assembly function for engine rebuilds.

Overview

This connecting rod kit is built to replace a worn or damaged rod in the 1984 Honda TRX200 engine. The connecting rod kit includes the rod, bearing, and pin needed to reconnect the piston to the crankshaft for proper power transfer. It is intended for riders and mechanics performing a top or bottom end rebuild on the TRX 200.

Built For Performance

• Forged construction for consistent strength under load
• Precision machined big end and small end bores
• Includes rod bearing for direct installation
• Cross-references OEM part number 13202-427-300
• Balanced to match original rod weight

Fits These Machines

• for Honda TRX200 1984

On-The-Job Use

• Engine top end rebuilds
• Bottom end servicing on TRX200 models
• Restoring a seized or knocking engine
• Routine crankshaft reassembly

Specs At A Glance

Good To Know

Q: Does this kit include the rod bearing? A: Yes, the kit includes the connecting rod with its bearing for direct installation. Q: Can I install this without splitting the cases? A: No, connecting rod replacement requires splitting the crankcase for proper access.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.