Furnace Draft Inducer Motor / Exhaust Motor Assembly for Carrier Bryant Models

Furnace Draft Inducer Motor / Exhaust Motor Assembly for Carrier Bryant Models

This furnace draft inducer motor and exhaust motor assembly moves combustion gases safely out of the heat exchanger and up the flue for Carrier and Bryant furnaces.

Overview

This furnace draft inducer motor assembly provides the controlled draft that pulls exhaust gases through the heat exchanger and out the vent. It is built as a direct-fit replacement for worn or failed inducer motors on Carrier and Bryant furnaces. Technicians and homeowners alike can use this exhaust motor assembly to restore reliable venting and safe furnace operation.

Built For Performance

• Complete motor and blower wheel assembly ready for drop-in installation
• Sealed bearings for quiet, smooth rotation over a long service life
• Housing and gasket designed to match the original mounting footprint
• Balanced blower wheel for steady airflow and reduced vibration
• Thermally protected motor windings for safe continuous operation

Fits These Machines

• for Carrier furnaces
• for Bryant furnaces

On-The-Job Use

• Replacing a seized or noisy draft inducer motor during furnace service
• Restoring proper venting after a pressure switch fault diagnosis
• Routine HVAC maintenance on Carrier and Bryant heating systems
• Emergency repair when a failed inducer motor shuts down the furnace

Specs At A Glance

Good To Know

Q: How do I know my inducer motor needs replacing? A: Common signs include a humming motor that will not spin, grinding or squealing noises, and a furnace that trips its pressure switch and shuts down.

Q: Does this assembly include the blower wheel? A: This draft inducer motor assembly ships as a complete unit with the blower wheel attached so it can be installed as one piece.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.