GP2-U7252-00-00 Throttle Cable for Yamaha Wave Raider 760 1996

Throttle Cable for Yamaha Wave Raider 760

This throttle cable, OEM cross-reference GP2-U7252-00-00, links the handlebar lever to the carburetor for consistent throttle control on your Wave Raider 760.

Overview

This throttle cable is a direct-fit replacement for the Yamaha Wave Raider 760, delivering smooth lever travel from idle to full throttle. It follows the OEM routing so installation stays simple without modification. A solid choice for riders servicing a 1996 Wave Raider 760.

Built For Performance

• Built to OEM cross-reference GP2-U7252-00-00 for a precise fit
• Inner cable designed for smooth, low-friction lever travel
• Protective outer sheath resists water, fuel, and UV exposure
• Pre-formed ends for straightforward connection at lever and carburetor
• Corrosion-resistant materials suited to marine use
• Constructed to withstand repeated throttle cycling

Fits These Machines

• for Yamaha Wave Raider 760 (1996)

On-The-Job Use

• Replacing a frayed or stiff throttle cable during routine service
• Restoring proper throttle response on the water
• Seasonal maintenance for personal watercraft
• Shop repairs and DIY carburetor tuning

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: No, this is an aftermarket throttle cable that cross-references OEM number GP2-U7252-00-00. It is designed to fit and function like the original.

Q: Does this cable need adjustment after installation? A: Yes, throttle cables typically require free-play adjustment at the lever after fitting. Follow your service manual specs for correct cable tension.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.