HH4314-3 Front Mount Helm 1.4 Cu Hydraulic Outboard Steering Pump 150 HP Boat

Front Mount Helm 1.4 Cu Hydraulic Outboard Steering Pump for 150 HP Boats

This front mount helm is a 1.4 cubic inch displacement hydraulic steering pump that mounts at the dash to drive an outboard steering system rated up to 150 HP.

Overview

This front mount helm pump gives boaters a compact hydraulic steering control that mounts directly at the dash for an outboard setup. Its 1.4 cubic inch displacement moves fluid to the cylinder with steady, low-effort response at the wheel. It is aimed at boat owners replacing a leaking or stiff helm on craft running up to 150 HP.

Built For Performance

• 1.4 cubic inch displacement for balanced steering response on outboard setups
• Front mount configuration fits dash cutouts for clean, accessible installation
• Hydraulic pump design reduces steering effort at the wheel
• Rated for outboard applications up to 150 HP
• Compact body suits tight helm positions on smaller boats

Fits These Machines

• Outboard boats rated up to 150 HP
• Center console and runabout setups using hydraulic steering
• Single-outboard craft with front mount helm positions

On-The-Job Use

• Replacing a worn or leaking helm pump at the dash
• Steering control on fishing and leisure boats
• Hydraulic steering builds on outboard-powered hulls

Specs At A Glance

Good To Know

Q: Do I need to bleed the system after installing this helm? A: Yes, air must be purged from the steering lines after installation to get smooth response. Follow the helm and cylinder bleed procedure before use.

Q: Can this helm be used with any hydraulic steering cylinder? A: It works best matched to a cylinder and line set sized for the same system. Confirm hose fittings and cylinder compatibility before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.