Skip to product information
1 of 9

HVAC Blend Door Actuator 87106-0C140 Fit for Toyota Tundra SR TRD Pro Flex Gas

HVAC Blend Door Actuator 87106-0C140 Fit for Toyota Tundra SR TRD Pro Flex Gas

Regular price $121.09
Regular price Sale price $121.09
Sale Sold out
Quantity

HVAC Blend Door Actuator for Toyota

This HVAC blend door actuator, part number 87106-0C140, is a replacement servo for controlling air mixing in Toyota Tundra models including SR, TRD Pro, and Flex trims. It is a made-to-fit component for the original actuator position.

Overview

This HVAC blend door actuator is an aftermarket replacement that manages the blend door position to regulate cabin temperature. It fits for Toyota Tundra SR, TRD Pro, and Flex Gas models, restoring proper heating and cooling function. The actuator converts electrical signals from the climate control unit into mechanical movement of the air door.

Built For Performance

  • Durable plastic gears with metal output shaft for longevity
  • Low-current DC motor minimizes load on the HVAC control module
  • Sealed case protects internal circuit from moisture and dust
  • Plug-and-play design uses the existing connector and mounting points
  • Cycle-tested for 10,000 full rotations without failure

Fits These Machines

  • for Toyota Tundra SR
  • for Toyota Tundra TRD Pro
  • for Toyota Tundra Flex Gas

On-The-Job Use

  • Used when no heat or cold air comes from vents despite working compressor or heater core
  • Replaces a stuck actuator that causes one side to blow hot and the other cold
  • Installed during dash reassembly after HVAC case repairs

Specs At A Glance

Part Number(s) 87106-0C140
Type HVAC Blend Door Actuator
Compatible With for Toyota Tundra SR, TRD Pro, Flex Gas

Good To Know

Q: What happens if the blend door actuator fails? A: You will notice no temperature change when adjusting the dial, and often a clicking noise behind the dash. The door remains stuck in one position, limiting airflow to hot or cold.

Q: Is removal and installation straightforward? A: Yes, the actuator is located on the heater unit side and can be replaced by removing a few screws and the electrical connector. Most users complete the swap in under an hour.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details