I Beam 6.000" 2.100" .927" Bronze Bush 5140 Connecting Rods Fits Chevy SBC 350

I Beam Connecting Rods for Chevy SBC 350

These I beam connecting rods with bronze bushings measure 6.000 inches center to center with a 2.100 inch big end and a .927 inch pin bore, and they connect the crankshaft to the piston to transfer combustion force in small block Chevy 350 engines.

Overview

This set of I beam connecting rods is built for the Chevy SBC 350 and similar small block engines, with the 6.000 inch length, 2.100 inch big end bore, and .927 inch pin bore that high performance builds rely on. The bronze bushing in the small end reduces friction and supports the wrist pin under load. These connecting rods suit engine builders assembling or refreshing a 350 cubic inch small block.

Built For Performance

• I beam profile for a strong strength to weight ratio in a small block build
• 5140 steel construction for dependable strength under combustion loads
• Bronze bushing in the small end for reduced pin friction and wear
• 6.000 inch center to center length for stock and mild performance builds
• 2.100 inch big end bore and .927 inch pin bore for standard SBC fitment

Fits These Machines

• for Chevy SBC 350 small block V8 engines

On-The-Job Use

• Engine rebuilds and short block assemblies
• Mild performance street builds
• Replacing worn or damaged connecting rods

Specs At A Glance

Good To Know

Q: Do these connecting rods include bolts? A: Rod bolts are not confirmed as included, so verify the listing contents or source bolts separately before assembly.

Q: Can these rods be resized for my application? A: Big end resizing and pin fitting should be done by a machine shop to match your crankshaft and pistons.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.