Idler Wheel and Bearing 5.630" for Arctic Cat M1000 2008-2009 Sno-Pro R

Idler Wheel and Bearing for Arctic Cat M1000 Sno-Pro/R

This idler wheel and bearing assembly is a 5.630 inch replacement component for Arctic Cat M1000 Sno-Pro/R snowmobiles, built to keep the rear suspension and track running smoothly through hard riding.

Overview

This idler wheel and bearing for Arctic Cat M1000 Sno-Pro/R models is a direct replacement for worn suspension wheels on 2008 to 2009 machines. The idler wheel and bearing assembly supports the track, cuts vibration, and helps the skid frame track straight under load. It is aimed at riders maintaining or rebuilding a high output mountain sled.

Built For Performance

• Measures 5.630 inches in diameter to match the factory wheel size
• Supplied with the bearing for a complete replacement
• Wheel construction built for continuous track contact and cornering loads
• Sealed bearing resists snow, moisture, and trail debris
• Sized for the Sno-Pro/R rear suspension layout

Fits These Machines

• for Arctic Cat M1000 2008
• for Arctic Cat M1000 2009
• for Arctic Cat M1000 Sno-Pro/R 2008
• for Arctic Cat M1000 Sno-Pro/R 2009

On-The-Job Use

• Rear suspension idler wheel replacement during track or skid service
• Fixing noisy or dragging track rotation on a high mileage sled
• Routine maintenance before the mountain riding season
• Rebuilding a suspension after a hard season of deep snow riding

Specs At A Glance

Good To Know

Q: Is the bearing included with the wheel? A: Yes, the idler wheel and bearing are supplied together as one assembly, so no separate bearing order is required.

Q: Will this fit my Sno-Pro/R without modification? A: It is sized for the M1000 Sno-Pro/R rear suspension, but confirm your machine year and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.