Idler Wheel and Bearing 5.630" for Arctic Cat Pantera 600 2005

Idler Wheel and Bearing for Arctic Cat Pantera 600

This 5.630 in. idler wheel and bearing assembly replaces the worn or seized unit on your Arctic Cat Pantera 600, restoring smooth track glide and quiet operation.

Overview

This idler wheel and bearing fits Arctic Cat Pantera 600 machines from 2005. The complete wheel and bearing assembly keeps track tension steady and reduces drag along the skid frame. It is a direct-fit replacement part for riders maintaining their Pantera 600 for trail and utility use.

Built For Performance

• Complete 5.630 in. wheel and bearing assembly ready to install
• Two-piece design allows bearing removal for service or replacement
• Durable construction withstands constant track contact and load
• Designed to reduce rolling resistance and track wear
• Mounts to the factory idler wheel location on the skid frame

Fits These Machines

• for Arctic Cat Pantera 600 2005

On-The-Job Use

• Trail riding where smooth track rotation matters
• Utility and hunting use in cold, snow-packed terrain
• Routine undercarriage service when idler bearings fail
• Restoring a seized or noisy idler wheel to quiet operation

Specs At A Glance

Good To Know

Q: Does this wheel come with the bearing installed? A: Yes, it is a complete wheel and bearing assembly, so it mounts as a unit. Inspect the axle bolt and spacers during install.

Q: How often should idler wheels be replaced? A: Inspect them each season for bearing play, roughness, or shattered plastic. Replace any wheel that spins rough or has side play before it damages the track.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.