Idler Wheel and Bearing 5.630" for Arctic Cat Sabercat 600 EXT/LX 2004-2006

Idler Wheel and Bearing for Arctic Cat Sabercat 600

This 5.630 inch idler wheel and bearing assembly replaces the worn rear suspension wheel on 2004-2006 Arctic Cat Sabercat 600 EXT and LX snowmobiles, restoring smooth track rotation and proper slide rail alignment.

Overview

This idler wheel and bearing for Arctic Cat Sabercat 600 models keeps your rear suspension track running true in the 2004-2006 EXT and LX chassis. Engineered as a 5.630 inch direct-fit replacement, it is built for riders who need a dependable idler wheel and bearing after a season of hard trail miles. Installing a fresh idler wheel and bearing restores your snowmobile to proper track support and extends overall rear skid life.

Built For Performance

• 5.630 inch outside diameter matches factory idler wheel size for Arctic Cat Sabercat 600 suspension
• Assembled with a sealed bearing to keep out snow, water, and trail grit
• Durable molded wheel construction resists wear from continuous track contact
• Direct replacement idler wheel and bearing design for straightforward installation
• Balanced rolling surface reduces vibration and track stretch
• Built to hold up to the load of a fully studded track on the trail

Fits These Machines

• for Arctic Cat Sabercat 600, 2004-2006 EXT
• for Arctic Cat Sabercat 600, 2004-2006 LX

On-The-Job Use

• Trail rebuilding the rear suspension skid assembly
• Replacing a seized or cracked idler wheel before a long ride
• Seasonal maintenance when a bearing has worn out from water and grit
• Restoring track alignment on Sabercat 600 machines used for lake running and groomed trails

Specs At A Glance

Good To Know

Q: How many idler wheels does my Sabercat rear skid use? A: Most Arctic Cat Sabercat rear suspensions use multiple idler wheels, so inspect all of them and replace any with rough or seized bearings at the same time. Ordering extras while you have the skid out saves a second teardown.

Q: Can I install this idler wheel and bearing myself? A: Yes, with basic tools and the sled raised safely, the idler wheel and bearing mounts to the suspension rail with a single bolt. Torque to spec and spin the track by hand to confirm smooth rotation before riding.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.