Idler Wheel and Bearing 5.630" for Arctic Cat Sno-Pro 600 2009

Idler Wheel and Bearing for Arctic Cat Sno-Pro 600

This replacement idler wheel and bearing assembly measures 5.630 in and keeps the track running true on your Arctic Cat Sno-Pro 600 snowmobile.

Overview

This idler wheel and bearing assembly is a direct-fit replacement for the Arctic Cat Sno-Pro 600, sized at 5.630 in to match the factory spec. The idler wheel and bearing unit supports the track, cuts friction along the skid frame, and keeps the suspension running smooth. It suits riders replacing a worn or noisy wheel on a 2009 Arctic Cat Sno-Pro 600.

Built For Performance

• 5.630 in wheel diameter matches the original Arctic Cat Sno-Pro 600 spec
• Sealed bearing keeps grease in and trail debris out
• Durable wheel body resists flex under track load
• Bearing pressed and ready to bolt onto the skid frame
• Direct replacement for the stock idler position

Fits These Machines

• for Arctic Cat Sno-Pro 600, 2009

On-The-Job Use

• Replacing a noisy or seized idler wheel on the skid frame
• Track support maintenance on the Arctic Cat Sno-Pro 600
• Trailside or shop rebuilds of the rear suspension

Specs At A Glance

Good To Know

Q: How many idler wheels does my sled need? A: Most skid frames use several idler wheels, so inspect each one and replace those with play or rough bearings. Q: Do I need to remove the track to install it? A: Most idler wheels can be swapped with the skid frame in place, though access varies by model.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.