Idler Wheel and Bearing 5.630" for Arctic Cat ZR8000 El Tigre ZR 8000 2015-2017

Idler Wheel & Bearing for Arctic Cat

This idler wheel and bearing assembly is a direct-fit replacement for Arctic Cat ZR8000 El Tigre snowmobiles, measuring 5.630 inches in diameter to match stock skid frame specs.

Overview

This idler wheel and bearing assembly keeps your Arctic Cat ZR8000 El Tigre rolling smoothly through the rear suspension. As a complete idler wheel and bearing unit, it replaces a worn or seized component to restore track alignment and cut drag. It suits riders maintaining a ZR 8000 who want a reliable idler wheel and bearing at a sensible price.

Built For Performance

• 5.630 inch outer diameter matches factory ZR8000 El Tigre skid geometry
• Pre-installed sealed bearing keeps out snow, water, and trail grit
• Wear-resistant wheel stands up to continuous track contact
• Direct bolt-on fit for stock idler wheel mounting positions
• Complete wheel and bearing assembly simplifies the swap
• Balanced build helps minimize rear suspension vibration

Fits These Machines

• for Arctic Cat ZR8000 El Tigre 2015-2017
• for Arctic Cat ZR 8000 2015-2017

On-The-Job Use

• Trail riding where proper track alignment reduces drag and wear
• Hard-pack and lake running that put constant load on idler wheels
• Seasonal suspension service and bearing replacement
• Refreshing a high-mileage skid frame before winter

Specs At A Glance

Good To Know

Q: Does this come with the bearing already installed? A: Yes, this is a complete idler wheel and bearing assembly ready to bolt on. There is no need to source or press a separate bearing.

Q: Will this fit both sides of the skid frame? A: This wheel is designed for standard idler positions on the ZR8000 El Tigre rear suspension. Check your sled's parts diagram to confirm the location and quantity you need.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.