Idler Wheel & Bearing 5.630" for Arctic Cat Sno-Pro 500 2010-2014

Idler Wheel and Bearing for Arctic Cat

This idler wheel and bearing assembly is a replacement suspension component for Arctic Cat Sno-Pro 500 snowmobiles, guiding the track and keeping the rear skid running smoothly through the season.

Overview

This idler wheel and bearing assembly serves Arctic Cat Sno-Pro 500 owners who need to replace a worn or noisy wheel in the rear suspension. The idler wheel and bearing support the track, cut friction, and help maintain proper skid frame alignment for consistent handling. It is aimed at riders and mechanics handling their own suspension service on race-bred Sno-Pro chassis.

Built For Performance

• Bearing pre-fitted in the wheel hub for quick installation
• 5.630 inch diameter matches the original suspension geometry
• Wheel material stands up to continuous track contact
• Sealed bearing helps block out snow, moisture, and grit
• Complete wheel and bearing assembly replaces the worn original

Fits These Machines

• for Arctic Cat Sno-Pro 500, 2010-2014

On-The-Job Use

• Rear skid frame idler wheel positions on the Sno-Pro 500 chassis
• Suspension rebuilds and mid-season bearing service
• Track alignment and tension work
• Off-season maintenance before the next ride

Specs At A Glance

Good To Know

Q: What are the signs that this idler wheel needs replacing? A: A wheel that wobbles, grinds, or will not spin freely by hand usually means the bearing has failed. Replacing the whole wheel and bearing assembly is faster than pressing in a separate bearing.

Q: Can this wheel be installed with the skid frame in the sled? A: Some idler wheel positions are accessible with the skid still mounted, while others need the track loosened or the skid dropped. Follow your model's service manual for the correct approach.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.