Idler Wheel & Bearing 5.630" for Arctic Cat ZR 440 Sno-Pro ZR440 2002

Idler Wheel and Bearing for Arctic Cat ZR 440 Sno-Pro

This 5.630 inch idler wheel and bearing assembly is a direct replacement suspension component for the 2002 Arctic Cat ZR 440 Sno-Pro snowmobile.

Overview

This idler wheel and bearing for Arctic Cat keeps your rear suspension skid running smooth and true. The 5.630 inch wheel size matches the factory spec for the 2002 ZR 440, restoring proper track alignment. It is a straightforward bolt-on replacement for riders maintaining their Sno-Pro sled.

Built For Performance

• 5.630 inch outer diameter wheel sized to factory spec
• Sealed bearing pressed into the wheel hub
• Durable construction built for high-mileage suspension duty
• Direct replacement fit for the 2002 ZR 440 chassis
• Resists wear from continuous track contact

Fits These Machines

• for Arctic Cat ZR 440 Sno-Pro 2002

On-The-Job Use

• Rebuilding a worn rear suspension skid
• Restoring smooth track alignment on trail rides
• Replacing a seized or damaged idler wheel
• Scheduled suspension maintenance between seasons

Specs At A Glance

Good To Know

Q: Does this come with the bearing already installed? A: Yes, the bearing is pressed into the wheel hub so it is ready to mount. Q: How do I know if my idler wheel needs replacing? A: A rough spinning wheel, side-to-side play, or visible flat spots signal it is time for a new one.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.