Idler Wheel Rubber 5.13" for Moto-Ski Nuvik 300 300T 1976-1977

Idler Wheel Rubber 5.13" for Moto-Ski Nuvik

This idler wheel rubber is a 5.13 inch replacement component for Moto-Ski Nuvik snowmobile suspension, designed to restore smooth track guidance and reduce slide rail wear.

Overview

This idler wheel rubber provides a fresh running surface for your Moto-Ski Nuvik suspension, helping the track roll smoothly and evenly. It is made for riders and mechanics replacing worn or cracked rubber on 1976-1977 Nuvik models, including the 300 and 300T sleds. The 5.13 inch idler wheel rubber keeps track alignment steady and cuts down on vibration through the skid frame.

Built For Performance

• 5.13 inch outside diameter for correct track contact
• Rubber construction resists cracking and wear from cold weather use
• Direct replacement for worn or missing idler wheel rubber
• Helps maintain proper track tension and alignment
• Designed for vintage Moto-Ski Nuvik suspension assemblies

Fits These Machines

• for Moto-Ski Nuvik 300, 1976-1977
• for Moto-Ski Nuvik 300T, 1976-1977

On-The-Job Use

• Replacing cracked or flattened idler wheel rubber on the rear skid
• Track alignment service and suspension rebuilds
• Vintage snowmobile restoration projects
• Routine maintenance before the riding season

Specs At A Glance

Good To Know

Q: How many idler wheel rubbers should I replace at once? A: Inspect all wheels on the skid and replace any that are cracked, flat spotted, or loose on the hub. Replacing them in sets helps keep track tension even across the suspension.

Q: Does the idler wheel rubber come with the wheel itself? A: This listing covers the 5.13 inch rubber component; check your existing wheel and mounting hardware before ordering. Confirm the diameter and fitment against your Nuvik before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.