Ignition Coil Pack For Chrysler Plymouth Dodge Jeep - C506

Ignition Coil Pack for Chrysler Plymouth Dodge Jeep

This ignition coil pack, reference C506, delivers the high voltage needed to fire the spark plugs on a range of Chrysler, Plymouth, Dodge, and Jeep vehicles, replacing a failed or weak coil to restore reliable spark.

Overview

This ignition coil pack is a replacement ignition component that steps up battery voltage to fire the spark plugs. It is built for Chrysler, Plymouth, Dodge, and Jeep applications and carries the C506 reference number for cross-checking fitment. Installing a fresh ignition coil pack restores consistent spark and smooths out misfires caused by a failing original coil.

Built For Performance

• C506 reference number for cross-checking against the original coil
• Sealed coil housing that protects windings from heat and moisture
• Direct-fit mounting pattern matching the factory coil location
• Designed to deliver stable high voltage across the rpm range
• Plug-in electrical connection matching the factory harness

On-The-Job Use

• Replacing a coil that causes misfires, rough idle, or hard starting
• Ignition tune-ups on older Chrysler, Plymouth, Dodge, and Jeep engines
• Restoring spark after a no-start condition traced to weak coil output
• Routine maintenance on high-mileage vehicles

Specs At A Glance

Good To Know

Q: How do I know if my ignition coil pack needs replacing? A: Common signs include engine misfires, rough idle, hard starting, and a check engine light with a misfire code. Confirm the coil is the cause with a diagnostic check before replacing it.

Q: Can I install this ignition coil pack myself? A: Yes, coil replacement is usually a straightforward job with basic hand tools on these engines. Disconnect the battery and match the C506 reference to your original coil before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.