Ignition Module for Sea-Doo GTX 650 1994-1995 Fits Personal Watercraft

Ignition Module for Sea-Doo

This ignition module for Sea-Doo replaces the factory spark control unit on 1994 to 1995 GTX 650 personal watercraft, restoring reliable spark timing for consistent engine starts.

Overview

This ignition module for Sea-Doo is a direct replacement electronic component for 1994 to 1995 GTX 650 watercraft. The module controls spark timing so the engine fires at the right moment through the rpm range. It suits riders replacing a failed stock ignition module for Sea-Doo on a GTX 650.

Built For Performance

• Controls ignition timing across the full operating rpm range
• Sealed housing resists moisture and spray common on personal watercraft
• Plug-in connectors match the factory wiring layout
• Solid-state electronics with no moving parts to wear out
• Built to original equipment style dimensions for a drop-in fit

Fits These Machines

• for Sea-Doo GTX 650, 1994
• for Sea-Doo GTX 650, 1995

On-The-Job Use

• Restoring spark on a GTX 650 that will not start
• Replacing a heat or moisture damaged ignition module
• Routine ignition service on older two-stroke watercraft
• Getting a stored or off-season ski running again

Specs At A Glance

Good To Know

Q: How do I know the ignition module is the problem? A: A no-spark condition or erratic running after checking the stator, coils, and wiring often points to the module. Test the ignition circuit per the service manual before replacing parts.

Q: Does this module need programming? A: No, it is a plug-in replacement that works with the existing ignition system. Connect the factory harness and mount it in the original location.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.