Ignition Module for Sea-Doo SPI 580 1991-1996 PWC Part

Ignition Module for Sea-Doo SPI 580

This ignition module is a replacement electrical part that provides the spark signal your Sea-Doo SPI 580 needs for consistent starting and running.

Overview

This ignition module is designed to restore reliable spark control to a Sea-Doo SPI 580 watercraft. The ignition module governs ignition timing so the engine fires evenly and holds power through the rev range. It fits 1991 through 1996 SPI 580 models for owners replacing a worn or failed unit.

Built For Performance

• Direct-fit replacement for the stock module
• Solid-state construction for steady spark timing
• Sealed body resists water and vibration
• Plug-in connector matches factory wiring
• Built for continuous marine operation
• Mounts in the original location without modification

Fits These Machines

• for Sea-Doo SPI 580 (1991-1996)
• for Sea-Doo models running the 580 engine platform

On-The-Job Use

• Fixing a no-spark condition on an SPI 580
• Replacing a corroded or heat-damaged module
• Electrical refresh during off-season service
• Getting a stored watercraft running again

Specs At A Glance

Good To Know

Q: What symptoms point to a bad ignition module? A: Weak or absent spark, hard starting, and misfiring under throttle are typical. Check spark and resistance against the service manual before ordering.

Q: Will this module work on any SPI 580 year? A: It is listed for 1991 through 1996 SPI 580 machines. Verify your model year and connector style before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.