Ignition Points for Arctic Cat Snowmobile with Kawasaki 292 cc Engine
Ignition Points for Arctic Cat Snowmobile with Kawasaki 292 cc Engine
Couldn't load pickup availability
Ignition Points for Arctic Cat Snowmobile with Kawasaki 292 cc Engine
These ignition points are a replacement contact set that restores spark timing on an Arctic Cat snowmobile running the Kawasaki 292 cc engine, and they cross to the contact breaker assembly found in that ignition system.
Overview
These ignition points serve as the contact breaker set for an Arctic Cat snowmobile equipped with the Kawasaki 292 cc engine. The points open and close the primary circuit so the coil can fire at the correct moment, which keeps the Kawasaki 292 cc engine starting reliably and running clean. They are a direct-fit service part for riders rebuilding an older points-style ignition on an Arctic Cat snowmobile.
Built For Performance
- Contact pointset sized for the Kawasaki 292 cc engine ignition plate
- Hardened contact faces resist pitting and arc wear
- Spring tension set to return the arm cleanly at high rpm
- Mounting hole pattern matches the stock breaker plate
- Replaceable as a pair to keep both cylinders timed evenly
Fits These Machines
- for Arctic Cat snowmobiles factory-equipped with the Kawasaki 292 cc engine
On-The-Job Use
- Routine ignition tune-ups on vintage Arctic Cat snowmobiles
- Restoring spark after a no-start or weak-spark diagnosis
- Pre-season servicing before the first ride of winter
- Rebuilding a points ignition during an engine refresh
Specs At A Glance
| Type | Contact breaker point set |
| Engine | Kawasaki 292 cc |
| Application | Arctic Cat snowmobile |
| Sold As | Point set |
Good To Know
Q: Do I need to set the gap after installing these points? A: Yes, breaker points must be gapped and the timing checked after installation, since the gap controls when the coil fires. Use the specification for the Kawasaki 292 cc engine in your Arctic Cat snowmobile.
Q: Should I replace the condenser at the same time? A: It is common practice to fit a fresh condenser whenever new points go in, because a weak condenser accelerates contact wear. Replacing both together avoids a repeat teardown.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
