Ignition Sensor Pickup Coil for Polaris Pro-X 700 2003-2004 Pro-X2
Ignition Sensor Pickup Coil for Polaris Pro-X 700 2003-2004 Pro-X2
Couldn't load pickup availability
Ignition Sensor / Pickup Coil for Polaris Pro-X 700
This ignition sensor and pickup coil assembly is a replacement part that restores the trigger signal on the Polaris Pro-X 700, giving the ignition module the pulse it needs to time spark correctly.
Overview
This ignition sensor and pickup coil is made to replace a worn or failed trigger on the Polaris Pro-X 700 snowmobile. The pickup coil reads the flywheel and sends the timing signal to the ignition. It fits riders repairing a no-spark or misfire issue on their own sled.
Built For Performance
- Direct-fit replacement for the factory pickup coil location
- Coil and housing built to withstand engine bay temperatures
- Consistent trigger signal for stable ignition timing
- Sealed wiring resists moisture and vibration
- Bolt-in mounting with factory attachment points
Fits These Machines
- for Polaris Pro-X 700 (2003-2004)
- for Polaris Pro-X2 700
On-The-Job Use
- Trail and mountain riding
- Ignition diagnostics and repair
- Rebuilding a sled with weak or no spark
- Pre-season maintenance
Specs At A Glance
| Part Type | Ignition Sensor / Pickup Coil |
| Fitment | Polaris Pro-X 700, 2003-2004 |
Good To Know
Q: How do I know the pickup coil is the problem? A: Symptoms like no spark, hard starting, and misfire after warm-up point to the pickup coil, but the stator and CDI should also be tested. A resistance reading against your manual spec confirms it.
Q: Does replacing the pickup coil require removing the flywheel? A: On most Polaris Pro-X 700 models the flywheel must come off to reach the pickup coil, so a flywheel puller and torque wrench are needed. Follow your service manual for the correct procedure.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
