Ignition Sensor Pickup Coil for Polaris RMK 600 2002-2003
Ignition Sensor Pickup Coil for Polaris RMK 600 2002-2003
Couldn't load pickup availability
Ignition Sensor / Pickup Coil for Polaris RMK 600
This ignition sensor and pickup coil assembly delivers the trigger pulse that keeps spark timing accurate on the 2002 to 2003 Polaris RMK 600. Mounted at the stator, the pickup reads the flywheel trigger and passes the signal to the CDI, so the ignition sensor stays reliable through cold starts and long pulls.
Overview
This ignition sensor / pickup coil is a replacement part built for the Polaris RMK 600 snowmobiles produced from 2002 to 2003. It sends the crank position signal the CDI uses to time spark, which keeps the engine starting predictably and running smoothly across the powerband. It is aimed at riders chasing a no-spark or intermittent spark fault who want a direct-fit ignition sensor for their RMK 600.
Built For Performance
- Replacement pickup coil matched to the RMK 600 ignition circuit
- Molded coil housing designed to handle heat and vibration near the flywheel
- Factory-style mounting points and lead routing for a clean install on the stator plate
- Produces a consistent trigger signal for stable spark timing
- Sealed connector helps block moisture and oil contamination
- Fits the listed 2002 to 2003 RMK 600 model years
Fits These Machines
- for Polaris RMK 600 (2002-2003)
On-The-Job Use
- Replacing a pickup coil that has caused weak or missing spark
- Restoring ignition timing after heat or vibration damage to the original sensor
- Ignition troubleshooting and repair on RMK 600 sleds
- Shop or trailhead repair of a no-start condition traced to the stator
Specs At A Glance
| Part Number(s) | RMK 600 Ignition Sensor / Pickup Coil |
| Type | Ignition sensor / pickup coil |
| Fitment Years | 2002-2003 |
Good To Know
Q: What symptoms point to a bad pickup coil? A: Common signs include no spark, hard starting, and spark that fades once the engine heats up, and a resistance check at the connector can confirm it. Q: Does this need flywheel removal to install? A: The pickup mounts to the stator plate under the flywheel on most RMK 600 sleds, so the recoil and flywheel typically come off for access.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
