Ignition Sensor Pickup Coil for Polaris RMK 600 HO 2006
Ignition Sensor Pickup Coil for Polaris RMK 600 HO 2006
Couldn't load pickup availability
Ignition Sensor / Pickup Coil for Polaris
This ignition sensor and pickup coil assembly for Polaris snowmobiles delivers the trigger signal your CDI needs to fire the spark at the right moment.
Overview
This ignition sensor and pickup coil is a direct replacement trigger assembly for Polaris RMK 600 HO snowmobiles from 2006. The pickup coil reads the flywheel trigger and sends that timing pulse to the ignition box so the engine fires on schedule. It is built for riders who need a reliable ignition sensor for Polaris RMK 600 HO machines without paying original equipment prices.
Built For Performance
- Direct replacement for the factory pickup coil on 2006 RMK 600 HO models
- Wound coil delivers a clean trigger signal to the CDI box
- Sealed construction resists moisture, snow, and engine heat
- Pre-terminated leads and factory-style connector for straightforward installation
- Mounting holes match the stock stator plate location
Fits These Machines
- for Polaris RMK 600 HO, 2006
On-The-Job Use
- Replacing a failed pickup coil that has caused a no-spark condition
- Restoring consistent ignition timing on high-mileage RMK 600 HO engines
- Trailside or shop repair after water intrusion damages the original sensor
- Seasonal maintenance on deep snow and mountain riding machines
Specs At A Glance
| Part Type | Ignition Sensor / Pickup Coil |
| Fits Model | for Polaris RMK 600 HO, 2006 |
| Placement | Stator plate, crankcase mounted |
Good To Know
Q: How do I know my pickup coil has failed? A: A failed ignition sensor for Polaris RMK 600 HO usually shows up as no spark, weak spark, or an engine that cuts out once it warms up. Check resistance across the coil leads against your service manual spec before replacing.
Q: Does this sensor need any adjustment after install? A: The coil bolts to the stator plate in a fixed position, so no air gap setting is required on this application. Confirm the connector clicks in fully and that the flywheel trigger passes the sensor cleanly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
